Eaton Electrical 1250-3000 VA manual Recycling the Used Battery or UPS, R N I N G

UPS MAINTENANCE

4.Replace the EBM. See “Recycling the Used Battery or UPS” on page 50 for proper disposal.

5.For tower models only. Install the joining bracket between cabinets.

6.Plug the new EBM into the UPS as shown in Figure 29.

For additional EBMs, plug the EBM cable into the battery connector on the adjacent EBM.

7.Plug the EBM communication cable into the RJ-11 port. Repeat for each EBM.

Recycling the Used Battery or UPS

Contact your local recycling or hazardous waste center for information on proper disposal of the used battery or UPS.

W A R N I N G

SDo not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of batteries is required. Refer to your local codes for disposal requirements.

SDo not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes. It may be toxic.

C A U T I O N

Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead-acid batteries and must be disposed of properly. For more information, contact your local recycling/reuse or hazardous waste center.

C A U T I O N

Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal, contact your local recycling/reuse or hazardous waste center.

50EATON Powerware® 5130 Rack/Tower UPS (1250–3000 VA) User’s Guide S 164201730 Rev 2 www.powerware.com