Eclipse Combustion 5600, VeriFlame Single Burner Monitoring System Internal Fault

	Table 9.2 Remote Display Diagnostic Messages (continued)
MESSAGE	TYPE	EXPLANATION
UNSAFE FLAME ON	Hold	Flame signal—actual, induced, or runaway scanner—is detected be-
		fore start-up or after shutdown. The fan is energized. If the cause is
		corrected within 30 seconds, as in afterburn, the control will turn
		off the fan and continue the sequence.
UNSAFE FLAME ON	Lockout	Same conditions as above, except the cause has not been corrected
XX:XX:XX LOCKOUT		within 30 seconds, resulting in a lockout and the alarm being energized.
UNSAFE–FLM–PURGE	Hold	For purge & modulation models: Flame signal—actual, induced,
		or runaway scanner—is detected during the selected purge time
		period. The fan is energized. If the cause is corrected within 30 sec-
		onds, as in afterburn, the control will turn off the fan and continue
		the sequence.
UNSAFE–FLM–PURGE	Lockout	For purge & modulation models: Same conditions as above,
XX:XX:XX LOCKOUT		except the cause has not been corrected within 30 seconds, resulting
		in a lockout and the alarm being energized.
V–INTERNAL FAULT	Lockout	Internal control failure; replace controller.
XX:XX:XX LOCKOUT
WATCHDOG FAIL	Lockout	Internal control failure; replace controller.
XX:XX:XX LOCKOUT
XXXXXXX	Status	In combination with other messages, shows the control is in the
XXXXXTESTXX		minimum pilot test mode.

Eclipse Veri-Flame Instruction Manual 818 -2/02

40