Eclipse Combustion VeriFlame Single Burner Monitoring System Remote Display Diagnostic Messages

	Table 9.2 Remote Display Diagnostic Messages (continued)
MESSAGE	TYPE	EXPLANATION
MAIN FLAME ON	Lockout	Main valve has been energized and main flame proven during trial
		for ignition.
MAIN FLAME ON	Status	Pilot valve is de-energized and main flame is on.
PILOT OFF
MAIN VALVE FAIL	Lockout	For purge and no purge models: Main valve closed switch is
XX:XX:XX LOCKOUT		open before start-up or after burner shutdown.
NO PURGE SELECT	Lockout	For purge & modulation models: No purge time was selected;
XX:XX:XX LOCKOUT		lockout prior to purge to high fire.
PILOT FLAME FAIL	Lockout	Pilot flame was not established during the pilot trial for ignition.
XX:XX:XX LOCKOUT
PILOT ON	Status	Pilot flame is proven; transformer is de-energized; remaining count-
		down for pilot trial for ignition is.
PILOT TRIAL FOR	Status	Pilot valve and ignition transformer are energized; countdown for
IGNITION		pilot trial for ignition begins.
POST PURGE	Status	For purge & modulation models: 15 second post purge is
		started on burner shutdown.
PROGM SWITCH ERR	Lockout	DIP switch improperly set or changed during cycle.
XX:XX:XX LOCKOUT
PURGE TO HIGH	Status	For modulation models only: Modulating motor is sent to high
FIRE		fire.
PURGE TO LOW	Status	For modulation models only: Modulating motor is sent to low
FIRE		fire.
RELAY FAIL	Lockout	Internal relay(s) fail initial check. Check ratings. If lockout still oc-
XX:XX:XX LOCKOUT		curs after overload is eliminated, replace control.
SAFE START OK	Status	Control has completed internal safe-start check.
UNSAFE AIR SHORT	Status	For purge & modulation models: Combustion air switch is closed
		before start-up or after shutdown; control holds start-up until switch
		reopens; if interlocks close before switch opens, alarm is energized.
UNSAFE AIR SHORT	Lockout	For purge & modulation models: Same conditions as above,
XX:XX:XX LOCKOUT		except the interlocks close before the switch reopens, causing a
		lockout and the alarm being energized.

Eclipse Veri-Flame Instruction Manual 818 -2/02

39