Appendix C: Command Line Reference

Phone 191

 

 

Phone

ENABLE PHONE ALTRING channel

DISABLE PHONE ALTRING channel

Valid context: General

If you have two phone numbers assigned to phone port, the DIVA LAN ISDN Modem assigns a distinctive ring to each number.

If you ENABLE PHONE ALTRING for a port, the assigned rings are swapped.

channel: PHONE port number. Range: 1 to 2.

ENABLE PHONE CALLBUMPING

DISABLE PHONE CALLBUMPING

Valid context: General

Enables or disables call bumping. Call bumping is only effective if you are using MLPPP, MLPPP+BACP, or MLPPP+AO/DI. When enabled, an incoming or outgoing voice call will temporarily disconnect one channel of an active data call. If PPP is in use on both B-channels, then call bumping does not work (incoming and outgoing calls will receive a busy signal).

ENABLE PHONE CALLWAITING [port]

DISABLE PHONE CALLWAITING [port]

Valid context: General

Enables or disables call waiting for analog phones (POTS).

port: Phone port number. Range: 1 to 2. Default: applies to both ports.

ENABLE PHONE CALLS channel [IN OUT]

DISABLE PHONE CALLS channel [IN OUT]

Valid context: General

Enables or disables incoming and/or outgoing POTS phone calls on a specific ISDN channel.

channel: ISDN channel. Range: 1 to 2.

IN: Enable/Disable incoming calls.

OUT: Enable/Disable outgoing calls.

SET PHONE RING FREQUENCY {0 20 25 40 50}

Valid context: General

Specifies the ringer frequency for phones connected to the PHONE ports.

0:The ring frequency is determined by the country setting (SET PHONE COUNTRY). 20, 25, 40, 50: Ringer frequency in hertz.

ENABLE PHONE CALLERID

DISABLE PHONE CALLERID

Valid context: General

Enables or disables caller ID for connected phones (POTS). When enabled, telephones with Call Display will display incoming call information.

Page 191
Image 191
Eicon Networks DIVA LAN ISDN manual Enable Phone Altring channel Disable Phone Altring channel