eMachines H3120 manual Adding or replacing a hard drive, 153, To add or replace a hard drive

www.emachines.com Adding or replacing a hard drive

5Slide the card reader out of the case.

6Slide the new card reader into the bay from the front of the case.

7Connect the new card reader’s USB cable to the system board.

8Use the screw you removed previously to secure the card reader to the bay.

9Replace the front bezel by following the instructions in “Replacing the front bezel” on page 147.

10Replace the side panel by following the instructions in “Replacing the side panel” on page 147.

Adding or replacing a hard drive

Tips & Tricks

You need a Phillips screwdriver to add or replace a hard drive.

To add or replace a hard drive:

1Remove the side panel by following the instructions in “Removing the side panel” on page 144.

2If you are adding a new drive, go to Step 4. If you are replacing an existing drive, go to the next step.

3Disconnect the power and data cables from the back of the hard drive.

153