eMachines H3120 manual 154, Remove the screw that secures the hard drive bay to the case

CHAPTER 13: Adding and Replacing Components www.emachines.com

4Remove the screw that secures the hard drive bay to the case.

Screw

5Slide the hard drive bay away from the system board and toward the open side of the case, then remove the hard drive bay from the case.

6If you are adding a new drive, go to Step 9. If you are replacing an existing drive, go to the next step.

7Remove the four screws that secure the hard drive to the drive bay. (Only the two screws on one side of the bay are shown below.)

Screws

8Slide the old drive out of the bay.

9Slide the new drive into the drive bay.

10Use the four screws you removed previously to secure the hard drive to the hard drive bay.

154