CHAPTER 13: Adding and Replacing Components

www.emachines.com

Replacing the memory card reader

Tips & Tricks

You need a Phillips screwdriver to add or replace a CD or DVD drive.

To replace the memory card reader:

Important

The color and shape of your replacement component's front cover may vary from your original component.

1Remove the side panel by following the instructions in “Removing the side panel” on page 144.

2Remove the front bezel by following the instructions in “Removing the front bezel” on page 146, but leave its wires connected to the system board. There should be enough slack in the cables to allow you to lay the bezel on its side in front of the case.

3Remove the single screw holding the card reader in the drive bay.

Screw

4Disconnect the card reader’s USB cable from the system board.

152

Page 159
Image 159
eMachines H3120 manual Replacing the memory card reader, 152, To replace the memory card reader, Screw