eMachines H3120 Adding or replacing an expansion card

Adding or replacing an expansion card
www.emachines.com
161
11 Insert the front bezel’s cables through the hole in the case behind the
bezel, then snap the bezel back into place.
12 Reconnect the front bezel’s power and LED cables to the appropriate
connectors on the system board.
13 Replace the side panel by following the instructions in “Replacing the side
panel” on page147.
Adding or replacing an expansion card
To add or replace an expansion card:
1Remove the side panel by following the instructions in “Removin g the side
panel” on page144.
2If you are adding a new expansion card, go to the next step. If you are
replacing an expansion card, go to Step4.
3Remove the screw that secures the expansion card slot cover to the case,
then go to Step 7.
4Disconnect any external cables that are attached to the expansion card
you are removing.
5Remove the screw that secures the expansion card to the case.
6Remove the PCI expansion card and place it in a static-free bag for storage.
You can gently rock the card end-to-end to loosen and remove the card
(do not bend the card sideways).
Screw
Screw