CHAPTER 13: Adding and Replacing Components

www.emachines.com

5Disconnect the front I/O panel cables from the system board.

6Remove the single screw that secures the front I/O panel to the case.

Screw

7Rotate the I/O panel down until it faces the tabletop, then pull the I/O panel and its cables away from the case. Note the location of the hole through which the cables are threaded.

8Thread the new I/O panel’s cables through the hole in the case, then insert the tabs in the bottom of the I/O panel into the slots in the front of the case.

9Rotate the I/O panel up until its screw hole aligns with the screw hole in the front of the case, then secure it to the case with the screw.

10Reconnect the I/O panel’s cables to the appropriate connectors on the system board.

160

Page 167
Image 167
eMachines H3120 manual 160, Screw