Emerson 3000 World Class, Instruction Bulletin, Figure A-25.High Temperature - Corrosive

Instruction Bulletin

Appendix A Rev. 3.9 May 2005

World Class 3000

Do not use sealant when installing the stainless steel tubes. Gas samples may become contaminated.

2.First install the stainless steel tubing on the fitting at the bottom of the probe junction box. Install the other end of the stainless steel tube onto the tube going to the probe (Figure A-25).

NOTE

If abrasive conditions of high ash con- tent and high velocity exist, an abra- sive shield is recommended. To balance out the wear on the shield, ro- tate the shield 90° every time the probe is powered down for service.

TEFLON

SLEEVES

STAINLESS

STEEL

TUBING

21240028

Figure A-25. High Temperature - Corrosive

Environment Kit

A-24 Appendices Rosemount Analytical Inc. A Division of Emerson Process Management