Emerson 3000 instruction manual World Class, Instruction Manual, e. Handling the Oxygen Analyzer

Instruction Manual

IB-106-300NH Rev. 4.3 May 2005

World Class 3000

9.An operator can set up, calibrate, or troubleshoot the IFT in one of two ways:

(a)Optional General User Interface (GUI). The GUI is housed within the IFT electronics enclosure and makes use of an LCD and keypad.

(b)Optional HART Interface. The IFT's 4-20 mA output line transmits an analog signal proportional to oxy- gen level. The line also carries all information normally accessed by use of the General User Interface LCD and keypad. This information can be accessed through the following:

1Rosemount Analytical Model 275/375 Handheld Communi- cator - The handheld commu- nicator requires Device Descriptor (DD) software spe- cific to the World Class 3000 product. The DD software will be supplied with many model 275/375 units, but can also be programmed into existing units at most Fisher- Rosemount service offices.

2Personal Computer (PC) - The use of a personal com- puter requires Cornerstone software with Module Library (ModLib) specific to the World Class 3000 product.

3Selected Distributed Control Systems - The use of distrib- uted control systems requires input/output (I/O) hardware and software which permit HART communications.

e. Handling the Oxygen Analyzer.

It is important that printed circuit boards and integrated circuits are handled only when adequate antistatic precautions have been taken to pre- vent possible equipment damage.

The oxygen analyzer is designed for industrial application. Treat each component of the system with care to avoid physical damage. The probe contains components made from ce- ramics, which are susceptible to shock when mishandled.

NOTE

Retain packaging in which the oxygen analyzer arrived from the factory in case any components are to be shipped to another site. This packag- ing has been designed to protect the product.

f.System Considerations

Prior to installation of your Rosemount Analytical World Class 3000 Oxygen Ana- lyzer with Intelligent Field Transmitter make sure that you have all of the components necessary to make the system installation. Ensure that all the components are properly integrated to make the system functional.

Once you have verified that you have all the components, select mounting locations and determine how each component will be placed in terms of available power supply, ambient temperatures, environmental con- siderations, convenience, and serviceability. A typical system installation is illustrated in Figure 1-2. Figure 1-3 shows a typical sys- tem wiring. For details on installing the indi- vidual components of the system, refer to Section 2, Installation.

1-4 Description and Specifications Rosemount Analytical Inc. A Division of Emerson Process Management