Emerson 3000 instruction manual World Class, Instruction Manual, IB-106-300NHRev. 4.3 May

Instruction Manual

IB-106-300NH Rev. 4.3 May 2005

World Class 3000

Do not install jumper JM6 on the mi- croprocessor board, or JM1 on the in- terconnect board, if an HPS is installed in the system. This will result in system failure.

3.The IFT must have JM6 on the micro- processor board (Figure 2-8 and Figure 2-9) and JM1 on the interconnect board (Figure 2-10 and Figure 2-11) installed if an HPS is not installed in the system.

4.If an MPS is not used in the system, wire jumper between CAL RET and NO GAS must be installed on the in- terconnect board. Remove wire jumper

if MPS is installed in the system. Refer to Figure 2-7, note 6.

5.The power cable should comply with the safety regulations in the user's country and should not be smaller than 16 gauge, 3 amp.

6.Before supplying power to the IFT, ver- ify that the jumpers have been properly set in the IFT (Figure 2-5, Figure 2-8, and Figure 2-10).

7.Terminal strip J5 on the power supply board is used for supplying the IFT with power. Terminal strip J6 on the power supply board is used to supply the probe heater with power if an HPS is not used (Figure 2-6).

						ALWAYS DISCONNECT LINE VOLTAGE
		JUMPER				FROM INTELLIGENT FIELD TRANSMITTER
		CONFIGURATION				BEFORE CHANGING JUMPERS.
LINE VOLTAGE	JUMPER					PROBE HEATER	JUMPER
SELECTION	(INSTALL)				VOLTAGE SELECTION		(INSTALL)
100 V.A.C.	JM3, JM7, JM2			WORLD CLASS PROBE (44V)			JM10
120 V.A.C.	JM8, JM7, JM1				218 PROBE (115V)		JM9
220 V.A.C.	JM6, JM5, JM2			WORLD CLASS "DIRECT			JM9
240 V.A.C.	JM6, JM5, JM1		REPLACEMENT" PROBE (115V)

21190012

If incorrect heater voltage is selected, damage to the probe may occur. For HPS voltage se- lection jumper, refer to Figure 2-15. Always update the relevant labeling to reflect the set voltage.

Figure 2-5. Power Supply Board Jumper Configuration

2-10 Installation Rosemount Analytical Inc. A Division of Emerson Process Management