Emerson 3000 World Class, Instruction Manual, 5-8CALIBRATE O2 SUB-MENU, 5-9SETUP SUB-MENU

Instruction Manual

IB-106-300NH Rev. 4.3 May 2005

World Class 3000

5-8 CALIBRATE O2 SUB-MENU 5-9 SETUP SUB-MENU

The CALIBRATE O2 sub-menu (Table 5-4) is used to enter the calibration mode. To access the CALIBRATE O2 sub-menu, press the CAL key at any time. The increase and decrease keys are used to scroll through the list.

The CALIBRATE O2 sub-menu has three se- lections available: Perform Calibration, View Constants, and Calibration Status. Refer to Table 5-4 for contents of the sub-menus.

Perform Calibration has two options depending on how Auto Cal is selected in Probe Setup. Refer to SETUP Setting in Table 5-4.

For information on performing a calibration, re- fer to Section 4, Calibration.

The SETUP sub-menu is used to enter all op- erator set variables into the system. To access the SETUP sub-menu press the SETUP key at any time. To select the parameter to be changed, move the cursor to the desired pa- rameter using the arrow keys. Press ENTER to select that parameter. To change the value for that parameter, use the arrow keys to increase or decrease the value. Press ENTER to save changes.

There are six selections available on the SETUP sub-menu: Calibration, O2 Calculation, O2 Alarms, Efficiency Calc., Relay Outputs, and Analog Outputs. Refer to Table 5-5 for the con- tents of the SETUP sub-menu, or ESCAPE to abort changes.

Table 5-3. PROBE DATA Sub-Menu

SUB-MENU
SELECTION	PARAMETER		DESCRIPTION
Process Data	O2	__% O2	O2 value for the probe.
	Efficiency	__%	Efficiency display.
	Stack Temp	__DegC	Stack temperature.
Diagnostic Data
Temperature	Cell	__DegC	Cell temperature of the probe.
	Stack	__DegC	Stack temperature.
	Cold Junct	__DegC	Cold Junction temperature.
Voltages	Cell	__mV	Cell voltage of the probe.
	Cell T/C	__mV	Cell thermocouple voltage of the probe.
	Stk T/C	__mV	Stack thermocouple voltage.
	Cold Jnt	__mV	Cold junction voltage.
Output Values	Analog	__% FS	Analog output voltage.
	K1 State	OFF/ON	Status of relay 1.
	K2 State	OFF/ON	Status of relay 2.

5-4 General User Interface (GUI) Operation Rosemount Analytical Inc. A Division of Emerson Process Management