Emerson 3000 instruction manual Jumpers on HPS Mother Board

Instruction Manual

IB-106-300NH Rev. 4.3 May 2005

World Class 3000

1

2

					ALWAYS DISCONNECT LINE VOLTAGE
					FROM HEATER POWER SUPPLY AND
		JUMPER			ANALOG ELECTRONICS (IF USED)
		CONFIGURATIONS			BEFORE CHANGING JUMPERS.
LINE VOLTAGE	JUMPER				HEATER	JUMPER
SELECTION	(INSTALL)				POWER
100/120 VAC	JM4, JM1				REMOTE	REMOVE JM2
220/240 VAC	JM5				ON	*INSTALL JM2
PROBE HEATER	JUMPER			ELECTRONICS		JUMPER
VOLTAGE SELECTION	(INSTALL)				SELECTION
WORLD CLASS PROBE	JM7		*ANALOG (EXISTING)			INSTALL JM3, JM6
(44V)
					DIGITAL	REMOVE JM3, JM6
218 PROBE (115V)	JM8		(NEXT GENERATION)

NOTES:

1100 VAC OPERATION REQUIRES TRANSFORMER PART NUMBER 1M02961G02.

2 REFER TO TABLE 3-5 FOR PROPER SET POINT SELECTION. 37840009

Figure 2-15. Jumper Selection Label

NOTE

Before supplying power to the heater power supply, verify that jumpers JM3, JM6 are removed and JM7 is installed. If relay wire (Figure 2-13, note 1) is in- stalled, JM2 must be removed from HPS Mother Board (Figure 2-16).

4.Before supplying power to the heater power supply, verify that the jumpers on the mother board, Figure 2-16, are properly configured. Jumpers JM3 and JM6 should be removed and JM7 should be installed.

Additionally, make sure that the proper jumper for your line voltage is installed, Figure 2-15. If relay wire (Figure 2-13, note 1) is not installed, JM 2 should be installed on the HPS Mother Board (Figure 2-16).

NOTE

Refer to Figure 2-8 and Figure 2-10 for proper IFT jumper configuration. IFT microprocessor and interconnect board jumper configurations must be set correctly in order for HPS to work properly.

FUSES

JM1

JM2

JM4

JM7

JM5

3D3 080G REV

FUSE

NOTE: ALL FUSES ARE 5A @ 250 VAC,

ANTI-SURGE, CASE SIZE

5 X 20 MM, TYPE T TO IEC127,

SCHURTER.29850001

Figure 2-16. Jumpers on HPS Mother Board

2-20 Installation Rosemount Analytical Inc. A Division of Emerson Process Management