Emerson 4000 manual Not Used Line

Instruction Manual

IB-106-340 Rev. 3.0 December 2003

Oxymitter 4000

5VDC

(SELF-POWERED)

TO REMOTE

CONTACT INPUT						5 - 30 VDC TO RELAY OUTPUT
	CONNECTION						CONNECTIONS
			4-20 mA		NOT USED					LINE IN	90 - 250 VAC,
						CAL FAIL		IN CAL
	CAL INITIATE		CONNECTION							GROUND	50/60 HZ LINE
+		-	+	-		+	-	+	-		VOLTAGE
										NEUTRAL	INPUT

							FACTORY
							WIRING TO
							OXYMITTER
							4000
BLACK	WHITE	YELLOW	BROWN	RED	BLUE	ORANGE	GREEN
FACTORY		FACTORY		NOT USED	FACTORY WIRING		FACTORY WIRING
WIRING		WIRING TO			TO INTERFACE BOARD		TO POWER SUPPLY
TO INTERFACE		OXYMITTER					BOARD
	BOARD		4000				26170027

Figure 2-12. SPS 4000 Electrical Connections

e. Connect Line Voltage f. Connect Remote Contact Input Wiring

Route the line voltage leads into the mani- fold through the 1/2 in. line voltage conduit fitting (Figure 2-3)and out through the bot- tom of the manifold. Connect the LINE IN and NEUTRAL leads to terminals L and N, respectively, as shown in Figure 2-12.Also, be sure to connect the ground wire to the ground lug. The unit automatically will con- figure itself for 90 to 250 VAC line voltage and 50/60 Hz. The power supply requires no setup.

To set up the SPS 4000 to initiate a calibra- tion from a remote location, route the 5 VDC calibration initiate contact input leads through the 1/2 in. NPT signal conduit port (Figure 2-3)and out through the bottom of the manifold. Connect the (+) and (-) CAL INITIATE leads to terminals 1 and 2, re- spectively, as shown in Figure 2-12.

2-16 Installation Rosemount Analytical Inc. A Division of Emerson Process Management