Using LANVIEW
Viewing the PoE Port Status
If the 7G4285‐49 or 7G4205‐72 is installed in an N5 chassis or if the 7G4285‐49 is receiving 48 Vdc from an external N‐POE Power System to support connections to PDs (Powered Devices), you can view the power status indications on the RX and TX LEDs. However, only one group of 12 ports may be viewed at a time. To view the PoE port status, refer to Figure 4‐1 and proceed as follows:
1.Press the GROUP SELECT button for more than one second. The DFE module will enter the PoE port status mode.
2.Now, every time you press the GROUP SELECT button for less than a second, the GROUP LED lights up in sequence, indicating which Group is selected. The PoE POWER STATUS for that group of segments is then indicated by the RX and TX LEDs for each segment. If there is power at the port, the RX LED is green and the TX LED is off. Otherwise, refer to Table 4‐1 for troubleshooting information.
3.Press the GROUP SELECT button again for more than one second. This returns the DFE module to the default status mode to monitor RX (receive) and TX (transmit) activity.
Table 4‐1 on page 4‐5 describes the LED indications and provides recommended actions as appropriate.
Note: The terms used in Table
• Flashing indicates LED is flashing randomly.
•Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).
•Solid indicates a steady LED light. No pulsing.
•Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.
