Using LANVIEW
Table 4-1 LANVIEW LEDs (continued)
LED | Color | State | Recommended Action |
|
| ||
RX/TX Indications in Standard Mode |
| ||
|
|
|
|
RX | Off | No link. No activity. Port | None. |
(Receive) |
| enabled or disabled. |
|
|
|
|
|
| Green | Solid. Link present, port | None. |
|
| enabled, no traffic is being |
|
|
| received by the interface. |
|
|
|
|
|
| Amber | Flashing. Link present, port | None. |
|
| enabled, traffic is being |
|
|
| received by the interface. |
|
|
|
|
|
| Red | Blinking. Indicates | Contact Enterasys Networks for |
|
| collisions. This indication is | technical support. |
|
| only supported on 10/100 |
|
|
| ports. |
|
|
|
|
|
TX | Off | Port enabled, but no activity. | If it is known that the port should be |
(Transmit) |
|
| active and is not, contact |
|
|
| Enterasys Networks for technical |
|
|
| support. |
|
|
|
|
| Green | Flashing. Indicates data | None. |
|
| transmission activity. Rate of |
|
|
| flashing indicates the data |
|
|
| rate. |
|
|
|
|
|
| Red | Flashing. Fault or Error | None, unless there is a high rate of |
|
| (collision). | activity. In this case, check for network |
|
|
| configuration problems or a defective |
|
|
| device. |
