To prevent damage during shipping, two shipping screws are attached to the transparency unit to secure its lamp assembly. You must remove these screws before using the transparency unit.
1.Turn the transparency unit so the glass side faces up.
2.Use a Phillips head (cross
head) screwdriver to remove the shipping screws, as shown at right.
3.Install the screws in the storage holes.
storage holes
If either screw is left in a shipping hole (the outer holes) while using the transparency unit, the unit may be damaged.
Before transporting the scanner, remove the transparency unit, reinstall the shipping screws, and turn the transportation lock on the right side of the scanner to the
icon. See “Transporting the Scanner” on page 125 for instructions.
Follow these steps to install the transparency unit on the scanner.
1.Make sure the scanner is turned off. Then unplug the power cable from the scanner.
2.Remove the document cover by grasping the back of the document cover and easing the cover up.
3.Make sure the document table is clean and dust free.
105