Error conditions
ERROR light | READY light | Error type |
|
|
|
N | N | Command error: The scanner has received incorrect |
|
| commands from your scanning software. Try rescanning |
|
| the document. |
F | O | Interface error: Check that your scanner is securely |
|
| connected to your computer, and then turn the scanner |
|
| off and back on again. |
F | F | Fatal error: Check that the transportation lock is released, |
|
| and then turn the scanner off and on again. If this doesn’t |
|
| solve the problem, call your EPSON dealer. |
O | O | Option error: There’s a problem with an installed option. |
|
| Check to make sure the transparency unit or automatic |
|
| document feeder is flat against the document table. |
|
| Check that your option is securely connected to the |
|
| option (ADF/TPU) connector at the back of the scanner. |
|
| Finally, check that the automatic document feeder isn’t |
|
| out of paper and doesn’t have a paper jam. If these |
|
| suggestions don’t solve the problem, call your EPSON |
|
| dealer. |
|
|
|
N= on, O = off, F = flashing
Scanner buttons
Button | Function |
|
|
P Operate | Turns the scanner on and off. |
Reset | Resets the scanner to its default settings after an error. Pressing this |
| button while scanning a document stops the scanner and may cause |
| an error. |
|
|
] Start | Automatically launches a ] Start |
| must set up your scanner software and a compatible application to |
| use this button. |
| If you installed Presto! PageManager, it’s automatically assigned to |
| the ] Start button. You can set up Presto! PageManager to scan your |
| image automatically and send it directly to another application or a |
| peripheral device, such as a printer. |
|
|
130