Loading non-standard sized film

Follow these steps to load non-standard sized film:

 

1. Place the film directly on the

calibration area

document table making sure

 

the glossy (smooth) side of the

 

film faces down.

 

If the reflective document mat is installed in the transparency unit, remove it.

2.Close the TPU and begin your scan.

If you’re using EPSON TWAIN Pro to scan, set the focus position to 0.0.

An area 2±1.5 mm from the horizontal and vertical edges of the document table glass will not be scanned.

The scanner will generate an error message if the calibration area is blocked. Also, dirt or dust on the calibration area can result in vertical lines being added to the image. Keep the calibration area clear and clean.

Scanning Reflective Documents

To scan reflective documents with the transparency unit installed, insert the reflective document mat included with the transparency unit.

1.Open the transparency unit. If there’s a film guide or transparency unit on the document table, remove it.

2.Slide the mat into place and

insert the tabs into the slots on the transparency unit.

112