Status and Error Messages

[E] SAVE MEMORY OVERFLOW

If this message appears when you are trying to save a macro with the SAVE MACRO option in SelecType Level 1, the printer does not have enough memory to save any additional macros. To correct this error, delete unused macros using the DELETE MACRO option in SelecType Level 1.

[E] SERVICE REQ. CXXX

A controller error has been detected. Write down the error number that appears in the right column of the display and turn off the printer. Turn the printer back on after a few seconds to see if the error message still appears. If it does, turn off the printer, unplug the power cord from the electrical outlet, and contact a qualified service person.

[E] SERVICE REQ. E00XX

A print engine error has been detected. Write down the error number that appears in the right column of the display and turn off the printer. Turn the printer back on after a few seconds to see if the error message still appears. If it does, turn off the printer, unplug the power cord from the electrical outlet, and contact a qualified service person.

[E] SET FULL PRINT

This message may appear when you are trying to print graphics or a mix of text and graphics. Press CONTINUE and then change the FULL PRINT setting in SelecType Level 1. See Chapter 3 for more information about setting this option.

[S] STANDBY MODE

When both CH P and CH S remain off for about thirty minutes, the printer enters standby mode and this message appears. Press any panel button or send data to warm up the printer. You can turn on and off the standby mode by setting the SelecType Level 2 STANDBY option.

Troubleshooting 7-7