PC Configuration
driver files and instructions on how to install them are provided together with the interface.
6.2.3Configure Access to the W3x WLAN
The configuration steps below will vary depending on both the operating system and the Wireless LAN interface installed on the PC. These steps provide a basic outline. For specific instructions, refer to the documentation provided with your Wireless LAN interface.
Configure the following wireless parameters on each of the wireless PCs:
•Set the Wireless LAN interface to use infrastructure mode. This configures the PCs to access each other and the Internet through the Ericsson W3x.
•Configure the network name (SSID) and channel to match the network name and channel configured on the Ericsson W3x. This information can usually be obtained through WLAN scanning. The network name is case sensitive.
•If you are using Wired Equivalent Privacy (WEP) security, configure the same encryption key that is configured on the Ericsson W3x.
•If you are using
•Configure the IP settings using the procedure described in section 6.1– IP Settings.
6.3USB Sharing Settings
When a storage device or printer is connected to the USB port on the Ericsson W3x, information about the device is displayed on the Sharing page.
To be able to use the shared device you also have to set up a connection to the shared device on your PC.
In some cases, you have to make sure that your PC belongs to the same workgroup as the Ericsson W3x. Follow the instructions in the next section to check the workgroup on your PC.
71 |
