Caution: You can install I/O modules only in slots 1 through 16 in the BlackDiamond 6816 or slots 1 through 8 in the BlackDiamond 6808. I/O modules do not fit in slots A, B, C, or D. Forceful insertion can damage the I/O module.
2Attach the ESD strap that is provided to your wrist and connect the metal end to the ground receptacle that is located on the
3For the BlackDiamond 6816, ensure that the module is horizontal with the module name to the left and that the ejector/injector handles are extended.
For the BlackDiamond 6808, ensure that the module is vertical with the module name at the top and that the ejector/injector handles are extended.
4Slide the module into the appropriate slot of the chassis (slots 1 through 16 in the BlackDiamond 6816 or slots 1 through 8 in the BlackDiamond 6808), until it makes contact with the backplane.
As the module begins to seat in the chassis, the ejector/injector handles begin to close.
5To close the ejector/injector handles, use both hands simultaneously to push the handles toward the center of the module.
6To secure the module, tighten the two screws using a #1 Phillips screwdriver.
Note: Tighten the screws before inserting additional modules. Otherwise, you might unseat modules that you have not secured.
7Repeat this procedure for additional modules, if applicable.
8Leave the ESD strap permanently connected to the chassis, so that it is always available when you need to handle
Removing I/O Modules
All BlackDiamond 6800 series modules (MSM64i and I/O modules) are
To remove an I/O module:
1Attach the ESD strap that is provided to your wrist and connect the metal end to the ground receptacle that is located on the
2Use a #1 Phillips screwdriver to unscrew the two captive screws.
Px Series Application Switch Installation and Configuration Guide |
