Extreme Networks Px Series manual Status Displays, SummitPx128 # show server details

Showing Configuration Details

Status Displays

The show health and show server details commands display similar (but not identical) information. The following examples illustrate the output from these commands (for the configuration shown in the example on page 10-4).

* SummitPx1:26 # show health Healthcheck is currently enabled

default interval 30 sec, retry interval 10 sec, arp interval 5 min

default fail after 2, restore after 2
15/15	ping	rx/tx
4 UP		4 *UP
flags: E - check Enabled, D - check Disabled,									R	-	mac	is	resolved
ra -	restore after,			fa -	fail	after,	left	-	secs		till next check
index	IP		port	proto	state check		left	run		ra	fa	ups	flg
1	10.65.8.50			ICMP	UP	IDLE	2	2		2	2	2	RE
1	0.65.8.50		8080	ICMP	*UP	IDLE	6	0		2	2	0	RE
2	10.65.8.51			ICMP	UP	IDLE	33	2		2	2	2	RE
2	10.65.8.51		8080	ICMP	*UP	IDLE	16	0		2	2	0	RE
40	10.65.8.52			ICMP	UP	IDLE	19	2		2	2	2	RE
40	10.65.8.52		80	ICMP	*UP	IDLE	39	0		2	2	0	RE
41	10.65.8.53			ICMP	UP	IDLE	16	2		2	2	2	RE
41	10.65.8.53		80	ICMP	*UP	IDLE	7	0		2	2	0	RE

*SummitPx1:28 # show server details

flags: E - check Enabled, D - down, U - Up, R - mac is resolved,

N - mac is not resolved, F - forced down

run - '>' than or '<' than 0, number of consecutive passed or failed

respectively
ra -	restore after,		fa -	fail	after, left - secs till next check
index	IP	port	proto	flg	curr-conns max-connections		run	ra	fa
1	10.65.8.50		ICMP	URE	0	10000	2	2	2
1	10.65.8.50	8080	ICMP	RE			0	2	2
2	10.65.8.51		ICMP	URE	0	10000	2	2	2
2	10.65.8.51	8080	ICMP	RE			0	2	2
40	10.65.8.52		ICMP	URE	0	10000	2	2	2
40	10.65.8.52	80	ICMP	RE			0	2	2
41	10.65.8.53		ICMP	URE	0	10000	2	2	2
41	10.65.8.53	80	ICMP	RE			0	2	2

Px Series Application Switch Installation and Configuration Guide 10-5