Extreme Networks Px Series manual Following commands can be passed from master to backup

Using VRRP with the SummitPx1

on the backup. After all the commands have been replaced, the configuration is saved and the box rebooted.

•Sends individual configuration commands from the master to the backup, where they are stored in local memory until a build command is issued on the master. The backup then executes the stored commands in sequence and issues its own build. The backup does not save the result. If you do not save it before the next boot, the configuration is lost.

To determine if the configurations of the master and backup match, use the command:

show vrrp auto-sync

This displays the current state of synchronization. For example:

Auto-sync:			Enabled
Master	Partner	IP:	Not Configured	N/A
Backup	Partner	IP:	10.65.4.250	Connected

------------------

MD5 (local config): c409f49b-911bca82-e5dc5fea-9cc0219c MD5 (Master config):

MD5 (Backup config): c409f49b-911bca82-e5dc5fea-9cc0219c

The following commands can be passed from master to backup:

configure server configure server-group configure service configure domain configure pattern-rule unconfigure server unconfigure server-group unconfigure service unconfigure domain unconfigure pattern-rule build

Use the following commands to control the VRRP auto-sync facility:

enable vrrp auto-sync disable vrrp auto-sync show vrrp auto-sync

configure vrrp auto-sync forcesync

configure vrrp auto-sync backup partner-ip <ip> configure vrrp auto-sync master partner-ip <ip>

Px Series Application Switch Installation and Configuration Guide 8-5