Extron electronic 168, 84, 1616 Quick Start CrossPoint 300 Matrix Switchers, cont’d, Create a tie

Quick Start — CrossPoint 300 Matrix Switchers, cont’d

RGBHV and Audio buttons select/deselect video and/or audio. The Audio LED blinks to indicate audio breakaway.

The Audio button and LED are present on video-only switchers, but have no function.

Audio also selects the audio level/adjust mode. See “View, adjust the audio level” at right.

Save or recall a preset

1. Save a preset — Press and hold the Preset button for 2 seconds.

Recall a preset — Press and release the Preset button.

Preset LED blinks.

Save a	Press and hold.
preset	2 seconds

PRESETPRESET

Create a tie

1. Press and release the Esc button to clear any input LEDs, output LEDs, or control LEDs that may be lit.

Press the Esc button to clear all selections.

The LED blinks once.

ESC

Preset LED lights.

Recall a Press and release. preset

PRESETPRESET

All input and output buttons with assigned presets light.

The configuration data at assigned preset locations will be overwritten.

1 2 3 4 5

2. Press and release the RGBHV and/or Audio I/O button(s) to select or deselect video and/ or audio as desired.

I/O

Lit when selected.	Off when deselected.
Off when deselected.	Lit when selected.

RGBHV AUDIO

3. Press and release the	The input LED	5
desired input button.
	lights to indicate

the selection.

4. Press and release the desired output button(s).

Output LEDs blink to indicate a potential tie.

3 4 8 ENTER

Enter LED blinks to indicate the need to confirm the change.

5. Press and release the Enter button. All input and output LEDs and the Enter LED go out.

2. Press and	1	The LED blinks to indicate that this preset
release the
desired		is selected.
		The Enter LED
input or
		blinks to indicate
output		the need to save or
button.		ENTER recall the preset.

3. Press and release the Enter button.

View, adjust the audio level

1.	Press and hold the				Audio LED blinks.
	Audio button.
2.	Press an input or			Hold
	output button. See				2 seconds
		AUDIO				AUDIO
	chapter 3 to read the
	displayed value.
	Output LEDs display the	7
	gain/attenuation.		Press an input button to

—or — adjust gain/attenuation.

Input LEDs display the	— or —
output volume level.

Press an output button to adjust the output

4 5 6 7 OUTPUTS

3. Increase and decrease the gain/attenuation or volume level by pressing the Esc () and

View () buttons.

4. Press and release the Audio button to exit.

VIEW	ESC
This button	This button
decreases	increases
the level.	the level.

QS-2 CrossPoint 300 Matrix Switchers • Quick Start