Extron electronic 128, 84, 1616, 1212, 124, 168 Example 6 Saving a preset, 33 - Clear all selections

Example 6: Saving a preset

The following steps show an example in which the current configuration is saved as a preset in a CrossPoint 300 1616. The steps show the front panel indications that result from your actions.

1. Press and release the Esc button (figure 3-33).

Press the Esc button to clear all selections.

CONTROL

The LED blinks once.

ENTER PRESET VIEW ESC

Figure 3-33 — Clear all selections

2.	Press and hold the Preset button for approximately 2 seconds until the Preset
	LED blinks (figure 3-34).
				Lit				Unlit
						(Preset Unassigned)
	Press and hold the Preset button until		(Preset Assigned)
	the Preset LED blinks.
		All input and output LEDs with
		assigned presets light.
	PRESET		1			2	3		4
				Preset 17	Preset 18		Preset 19		Preset 20
		If you then save the configuration to a lit preset number,
		the configuration data at that preset location will be overwritten.
Figure 3-34 — Enter Save Preset mode
3.	Press and release the Output 1 button (figure 3-35).

Press and release the Output 1 button.
The LED blinks to indicate that this preset
number is selected but not saved.	CONTROL

1	2	3	4	ENTER PRESET VIEW
Preset 17	Preset 18	Preset 19	Preset 20	The Enter LED blinks to indicate
				the need to save the preset.
				The Preset LED continues to blink.

Figure 3-35 — Select the preset

CrossPoint 300 Matrix Switchers • Operation 3-21