Installing the Netopia ISDN Modem

3-5

Caution! Do not connect the ISDN cable to the Netopia ISDN Modem’s RJ-11 analog device ports (identified by the telephone icon). These ports are designed for connecting standard analog telephone equipment.

5.Connect the other end of the cable to the RJ-11 or RJ-45 ISDN wall jack. An RJ-45 jack will accept your cable’s RJ-11 connector.

Caution! Do not connect the ISDN cable to a standard analog telephone jack or to an external ISDN network termination device (NT1). Make sure it is connected to an ISDN jack (also called an ISDN “U” interface).

6.Connect the Netopia ISDN Modem power cable to the connector labeled 9VDC on the back panel of the ISDN modem.

7.Plug the transformer end of the power cable into a standard AC wall outlet.

The LEDs on the front panel (see the front panel figure on page 3-1) flash momentarily as the ISDN modem undergoes a power-up self-test.

8.Turn on the computer’s power switch and restart.

9.To configure the Netopia ISDN Modem, see the “Configuration using a Macintosh computer” section on page 5-2.

Page 37
Image 37
Farallon Communications 612, 412 manual Installing the Netopia Isdn Modem