1-39
Installing and Removing the Data Pack 100
Referto Figure 1-43,Figure 1-44, and Figure 1-45.
Usethe following steps to install or remove the data pack:
FIGURE1-45. Data Pack 100 Installatio na nd Removal.
ToInstall the data pack:
1.Remove the ba ttery pack from the Communicator.Nex t, either remove the
MemoryModule orleave it assem bled to the Communicator.
2.The data pack iskeyed to prevent incorrect installation. When the
Communicatoris facing down, in sert the data packwith thepart number
labelfacing down; the hinge of the handle will be on the left. Press firmly in
placewith your fingers.
Toremove the data pack:
1.Insert the flat edge of a small screwdriver underthe outside edge of the
handle.Lift the handle to disconnect the data pack from its connector.
2.Raise the handle and pull t he data pack out of the Memory Module.