Frymaster 24G Series operation manual Gas Conversion Procedures cont, 3-13

24G SERIES FLATBOTTOM GAS FRYERS CHAPTER 3: INSTALLATION INSTRUCTIONS

3.7 Gas Conversion Procedures (cont.)

NON-CE UNITS ONLY:

See gas valve illustration below for reference when performing gas valve conversions.

When converting from natural gas to propane (or vice-versa), the following procedures apply:

♦Burner orifices and pilot orifice MUST be replaced (see page 3-11 for required component part numbers).

♦Adjust orifice gas pressure by turning the gas-valve adjustment screw (see page 3-11 for gas types and pressures).

♦After adjustment, replace the adjustment-screw cover.

♦Factory MUST be notified so the conversion can be documented and a new rating plate can be sent out.

Conversion from one gas family to another (i.e. changing from natural gas to propane) requires special components. Obtain the necessary components using the tables on page 3-11.

Conversions can only be executed by qualified, factory-authorized personnel.

Pilot pressure	Pressure flow adjustment	Pilot pressure	Thermocouple
adjustment (remove		adjustment	Connection
cover screw to access)	(remove cover screw to access)

Vent Tube

Connection

Pilot gas supply	ON/OFF Gas	OFF Button	ON Button- Pilot
connection.	Knob		Gas-Flow
Non-CE gas valve (typical)		CE gas valve (typical)

3-13