Fujitsu C-4120 Parallel Port Devices, Serial Port Devices, Usb Devices, Microphone, C A U T I O N

S e c t i o n F o u r

C A U T I O N

Windows 98 SE has a shutdown proce- dure for PC Cards that must be followed before beginning to remove a card.

Removing PC Cards

If you wish to remove or replace the PC Card, use the following procedure:

1.Close applications that are using the PC Card.

2.Double-click on the PC Card indicator on the Windows taskbar.

From the PC Card Properties Window:

3.Select the card to be removed and click on the Stop button.

4.Verify that the You can safely remove your card message appears.

5.If the device cannot be removed message appears, save all files, close all applications, exit Windows 98 SE and then shutoff the power with the power switch. (See Power Off on page 17.)

6.Slide the lock toward the rear of your notebook to release the card.

7.Flip the eject button toward the rear of your notebook until it is fully extended.

8.Press the eject button in until it is flush with the side of your notebook.

9.Grasp the card and pull it clear of your notebook. (See Figure 4-2.)

C A U T I O N

If the PC Card has an external connector and cable, do not pull on this cable when removing the card.

PARALLEL PORT DEVICES

To connect a parallel interface device to the parallel port, be sure that the connector is the right size and aligned, then push in until it is fully seated. When it is seated, tighten the hold- down screw on each end of the connector.

(See Figure 1-7 on page 9.)

SERIAL PORT DEVICES

To connect a Serial (RS-232C) device to the serial port, be sure that the connector is the right size and aligned, then push in until it is fully seated. When it is seated, tighten the hold- down screw on each end of the connector.

(See Figure 1-7 on page 9.)

USB DEVICES

When installing a device on the USB Port, be sure that the connector is the right size, aligned, and fully seated. (See Figure 1-7 on page 9.)

MICROPHONE

Make sure that your mono microphone is equipped with an 1/8" (3.5 mm) mono mini- plug. Make sure the plug is aligned and push it into the jack until fully seated. (See Figure 1-6 on page 8.)

52