Fujitsu C-4120 manual P O I N T, C A U T I O N

S e c t i o n T h r e e

Indicator panel above the keyboard of your notebook. (Figure 3-11.)Push the Power but- ton, when your notebook is active but no Access indicators are on and release the button (imme- diately). You will hear two short beeps and then your system will enter Suspend mode.

If your notebook is suspended, pushing the Power button will return your notebook to active operation at the point where it went into suspension. You can tell whether or not your system is in Suspend mode by looking at the Power indicator. (See page 20.) If it is visible and not flashing, your notebook is fully opera- tional. If it is visible and flashing, your note- book is in Suspend mode. If it is not visible, the power is Off or your notebook is in Save-to- Disk mode. (See page 37.) When you receive your LifeBook C Series it will be set to the default in BIOS, which is Suspend mode.

P O I N T

Disabling the Suspend/Resume function prevents it from being used to put your notebook in Standby or Save-to-Disk mode. The resume function of the but- ton cannot be disabled. (See the Power Menu of the BIOS setup utility, pages 43-44, for more information.)

C A U T I O N

The Standby or Save-to-Disk mode should not be used with certain PC Cards. Check your PC Card documentation for more information.

P O I N T

If your notebook is active when you enter the Standby or Save-to-Disk mode, changes to open files are not lost. The files are left open and memory is kept active during Standby mode or the memory is transferred to the internal hard drive during Save-to-Disk mode.

C A U T I O N

If you are running your notebook on battery power, be aware that the battery continues to discharge while your note- book is in Suspend mode, though not as fast as when fully operational. With a fully charged internal Lithium ion battery the suspend mode will maintain your status for 24 hours or more.

36