Fujitsu C-4120 manual Replacing the Battery, C A U T I O N

Replacing the Battery

The battery is installed in the battery bay on the underside of your notebook. (See Figure 4-1.)With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not charged. To swap batteries, have a charged battery ready to install and follow the steps below:

1.Press the Power button to put the notebook into suspend mode. (Or shut down your notebook and disconnect the AC adapter if you wish to cold-swap.)

2.Close your display and stand your notebook on it's right panel with the top facing you.

3.Press down on the battery release panel and slide it way from you.

4.Set your notebook down gently on it's top, with the left panel facing you.

5.Slide the battery pack away from the connector until it stops.

6.Lift the battery out of the bay.

U s e r I n s t a l l a b l e F e a t u r e s

7.Place the charged battery flat into the bay with the bottom up and the release panel away from you, approximately one quarter inch away from the connector in

the notebook.

8.Slide the new battery onto the connector.

9.Slide the battery release panel down until it clicks into place.

10.Press the Power button to resume from suspend mode if you are warm-swapping, or to power on your notebook if cold-swapping.

Batteries should be removed and stored sepa- rately in a cool dry place if your notebook is not going to be used for an extended period of time.

C A U T I O N

If the Lithium ion battery connector is not fully seated, you may not be able to use your notebook or charge your battery.

L i f e B o o k C S e r i e s f r o m F u j i t s u

Four

Figure 4-1 Replacing the Battery

49