Fujitsu C-4120 manual To Replace the original system memory, To Remove a Memory Upgrade Module

S e c t i o n F o u r

To Replace the original system memory:

Follow steps 1 to 6 above, then do the following:

7.At the right of the plastic sheeting is a small notch facing towards you. Ease your finger- nail under this notch, and lift the flap back exposing the memory upgrade slot.

8.Align the memory upgrade module with the chip side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. The connector will be pointing towards you.

Then follow steps 9 thru 15 to complete this upgrade.

C A U T I O N

Before you install or remove the memory upgrade module, save changes and close all files and turn power off to your note- book. (See Power Off on page 17.)

P O I N T

After installing your added memory module, you must complete the Resetting the Save-to-Disk Parameters procedure in order for the Save-to-Disk mode to operate properly on your LifeBook. (See page 46.)

To Remove a Memory Upgrade Module:

1.Perform steps 1 through 7 of To Install a Memory Upgrade Module.

2.Pull the clips sideways away from each side of the memory upgrade module at the same time.

3.While holding the clips out, remove the module from the slot by lifting it up and pulling towards the left of your notebook.

4.Store the memory upgrade module in a static guarded sleeve.

5.Close the keyboard by following the instruc- tions in steps 11 and 15 of the instructions for To Install a Memory Upgrade Module.

Checking the Computer

Recognition of New Memory Capacity

When you have changed system memory capacity by adding or removing a memory upgrade module, be sure to check that your notebook has recognized all of the memory. You can check memory capacity by looking at the Main menu of the setup utility:

1.Turn on power using the power switch.

2.Enter the setup utility by pressing the F2 key as soon as the Fujitsu logo appears on the screen. (See page 44.)

3.The System Memory and the Extended Memory capacity, as detected by your note- book during the Power On Self Test (POST), are displayed at the bottom of the Main menu screen.

56