Fujitsu C-4120 manual The Power button does not work

Problem

Shutdown and Startup Problems

L i f e B o o k C S e r i e s f r o m F u j i t s u

T r o u b l e s h o o t i n g

Possible Cause Possible Solution

The Power button does not work.

The system powers up, and displays power on information, but fails to load the operating system.

1.The Power button is disabled from

the Advanced submenu of the Power menu of the setup utility.

2.You did not hold the button in long enough.

3.There may be a conflict with the application software.

1.The boot sequence settings of the setup utility are not compatible with your configuration.

2.You have a secured system requiring a password to load your operating system.

3.Internal hard drive was not detected.

1.Enable the button from the setup utility. (See page 43.)

2.Hold the button longer. This may need to be a very long time if your application is preventing the CPU from checking for button pushes.

3.Close all applications, and try the button again.

1.Set the operating source by pressing the Esc key while the Fujitsu logo is on screen or use the F2 key and enter the setup utility and adjust the source settings from the Boot menu.

2.Make sure you have the right password. Enter the setup utility and verify the Security settings and modify them as appro- priate. (See Security Menu in the BIOS guide. See page 44 for more information.)

3.Use the BIOS setup utility Main menu, Primary Master submenu to try to auto detect the internal hard drive.

Five

75