Fujitsu C-4120 Flip the keyboard away from you, and set it down on the screen, C A U T I O N

6.Flip the keyboard away from you, and set it down on the screen.

7.In the center of the plastic sheeting under the keyboard is a small notch facing the right side on your notebook. Ease your fingernail under this notch, and lift the flap to your left, exposing the memory upgrade slot.

C A U T I O N

The memory upgrade module can be severely damaged by electro-static discharge (ESD). Be sure you are properly grounded when handling and installing the module.

8.Align the memory upgrade module with the chip side up. Align the connector edge of the memory upgrade module with the connector slot in the compartment. The connector will be pointing toward your right. (Figure 4-4.)

9.Insert the memory upgrade module at a 45° angle. (Figure 4-4.)Press the connector edge of the module firmly down and into the connector.

L i f e B o o k C S e r i e s f r o m F u j i t s u

U s e r I n s t a l l a b l e F e a t u r e s

10. Press the memory upgrade module down into the compartment until it lodges under the retaining clip. You will hear a click when it is properly in place.

11. Lay the flap of plastic sheeting back into place.

12. Flip the keyboard back over, and slide it back into place with the tabs going into the slots to the front of the notebook and hold- ing the back of the keyboard approximately on quarter inch up.

13. Let the back of the keyboard down, back into place.

14. Carefully press the panel which you removed back into place

15. Replace the screws and the screw covers.

The memory upgrade module is not something you routinely remove from your notebook. Once it is installed, you should leave it in place unless you want to increase system memory capacity.

Figure 4-4 Installing a Memory Upgrade Module and closing the compartment

Four

55