Fujitsu C-4120 manual Notebook fails to recognize DVD/CD-ROM continued

L i f e B o o k C S e r i e s f r o m F u j i t s u

T r o u b l e s h o o t i n g

Problem

Notebook fails to recognize DVD/CD-ROM (continued).

The DVD/CD-ROM Access indicator on the Status Indicator panel blinks at regular intervals when no DVD/CD is in the tray or the DVD/CD-ROM drive is not installed.

Possible Cause

5.Setup utility is set to something other than DVD/CD-ROM or Auto for the Secondary Master Controller.

6.Wrong drive designator was used for DVD/CD-ROM in the application.

7.Windows DVD/CD auto insertion function is disabled.

8.DVD/CD is dirty or defective.

1.The Windows DVD/CD auto insertion function is active and is checking to see if a DVD/CD is ready to run.

Possible Solution

5.Revise BIOS settings to set the Secondary Master correctly. (See Main menu and Primary Master submenu in the BIOS guide. See page 44 for more information.)

6.Verify the drive designator used by the application is the same as the one used by the operating system. When the operating system is booted from a DVD/CD-ROM drive designations are automatically adjusted. (See Boot Options submenu in the BIOS guide. See page 44 for more information.)

7.Start the DVD/CD from the desktop or application software or re-enable the Windows DVD/CD auto insertion function. (See DVD/CD-ROM Access Indicator on page 22 for more information.)

8.Wipe DVD/CD with a non-abrasive CD cleaning cloth and reinsert. If it still will not work try another DVD/CD in the drive.

1.This is normal. You can disable this function if you wish. (See DVD/CD- ROM Access Indicator on page 22 for more information.)

Five

63