Fujitsu C-4120 manual To Run the Emergency Recovery Program, P O I N T

L i f e B o o k C S e r i e s f r o m F u j i t s u

T r o u b l e s h o o t i n g

To Run the Emergency Recovery Program

To use this portion of the CD-ROM, your notebook must BOOT (upon power up or full system reset/restart) from the CD-ROM drive.

1.Insert the Emergency Recovery CD in the CD-ROM drive.

2.If your notebook is running when you insert the CD, exit your operating system and power down the notebook.

3.Start (power up) your notebook.

4.At this point, you must either change you BIOS setup configuration (F2 key) to have the computer boot from the CD-ROM "first" (if you have not previously done so), or use the Esc key during this boot-up sequence and select the CD-ROM from the menu which will appear. (For more information and detailed instructions on changing the BIOS setup see pages 43-44.)

5.If correctly configured to boot from the Recovery CD-ROM, you will notice your system runs a full virus scan of the hard drive and then reaches the Emergency Recovery Welcome screen. If this is not what is dis- played, check to see that the Recovery CD is installed in the CD-ROM drive and repeat the previous steps (starting with 2.).

If you received a message, "This program may not be used on your computer", you are using the wrong Recovery CD for this model of notebook. Contact Fujitsu PC Service and Support to obtain the correct CD.

6.Read the information displayed on the Welcome screen, then Click OK.

7.Select one of the two icons displayed in the Emergency Recovery menu and follow the instructions that follow.

8.When recovery is complete, remove the Recovery CD, replace it in its sleeve and store it in a safe location (with your Operating System Manual/Certificate of Authenticity).

9.Restart your notebook.

10.Reset your boot device priority in the BIOS setup as desired.

Your notebook now has all of the software installed that was included when you received it from the factory. You must now load any pro- grams which you purchased and installed after you got your notebook. If you chose the Format and Recover option, you should now restore your data files. If you performed Recovery with- out format, your data files will still exist (within their original directory structures).

P O I N T

As long as there is no bootable disk in the CD-ROM drive or the floppy disk drive, your notebook will boot from the hard drive regardless of the BIOS Boot Device Priority setting.

Five

85