Fujitsu C-4120 manual Theft Prevention Lock, To Install a Memory Upgrade Module, C A U T I O N

S e c t i o n F o u r

THEFT PREVENTION LOCK

A physical security system lock can be installed on the left rear panel of your notebook. (See Figure 1-5 on page 8 for the location of the lock slot.) Simply insert the key end of your security system in the slot, rotate 90 degrees and lock.

MEMORY UPGRADE MODULE

Your notebook has high speed SDRAM installed. To increase your memory capacity, you may install a memory upgrade module in the memory upgrade compartment under the status display panel of your notebook. You may also replace the original memory module to fur- ther increase your notebook's system memory. The memory upgrade module is a dual-in-line memory module (DIMM). You may add modules of different capacity. SDRAM modules are required. Please refer to the Accessories Insert for the available options.

C A U T I O N

Never remove screws except the ones specifically shown in the directions for installing and removing the memory upgrade module.

To Install a Memory Upgrade Module:

1. Shut Down your notebook (see Power Off on page 17) and remove any power adapter (AC or auto/airline).

2. Using the tip of your Phillips head screw driver, carefully pry the screw covers out of the screwholes just above both ends of your keyboard.

3. Carefully remove the two screws.

4. Press your display all the way open, then care- fully work the panel around the status indica- tor display loose, and set it out of the way.

5. Lift the back of the keyboard approximately
one quarter of an inch, and then pull it away
from you. Do not pull it too far, as it is	Figure 4-3 Opening the Memory Upgrade Compartment
still connected.

54