Fujitsu C-4120 Stereo Line In Device, Headphones, Telephone Lines, Mouse, Keyboard Or Keypad

L i f e B o o k C S e r i e s f r o m F u j i t s u

U s e r I n s t a l l a b l e F e a t u r e s

STEREO LINE IN DEVICE

Make sure that your stereo line in audio device, a cassette recorder, for example, is equipped with an 1/8" (3.5 mm) stereo mini-plug. Make sure the plug is aligned and push it into the jack until fully seated. (See Figure 1-6 on page 8.)

HEADPHONES

Make sure that your stereo headphones are equipped with an 1/8" (3.5 mm) stereo mini- plug. Make sure the plug is aligned and push it into the jack until fully seated.

(See Figure 1-6 on page 8.)

P O I N T

Plugging in headphones disables the built-in stereo speakers.

TELEPHONE LINES

To attach a telephone line to the internal modem open the rear panel connector cover or with the cover closed slide the panel in the con- nector cover slightly opened to reveal the Modem (RJ-11) jack. Plug one end of the tele-

phone cable into the telephone line outlet. Orient the telephone cable with the release latch on the connector up. Push it into the jack until it clicks and latches. (See Figure 1-6 on page 8.)

C A U T I O N

The internal modem is not intended for use with Digital PBX systems. Do not connect the internal modem to a digital PBX as it may cause serious damage to the internal modem or your entire note- book. Consult your PBX manufacturer’s documentation for details. Some hotels have Digital PBX systems. Be sure to find out BEFORE you connect your modem.

MOUSE, KEYBOARD OR KEYPAD

Make sure the connector on your device is the correct PS/2 type. Align the arrow on the connector to point to the bottom of your note- book and push it in until the connector seats. A mouse, keyboard or keypad may be installed

and automatically recognized by your note- book without restarting or changing setups. (See Figure 1-7 on page 9.)

EXTERNAL MONITOR

You may install an external monitor on the external monitor port on the rear panel of your notebook. Make sure that the wide side of the connector is down and attach it to the port by pushing in until it is seated, then tighten the hold-down screw on each end of the connector. (See Figure 1-7 on page 9.)

C A U T I O N

Pressing F10 while holding down the Fn key allows you to change your selection of where to send your display video. Each time you press the combination of keys you will step to the next choice. The choices, in order, are: built-in display panel only, external monitor only, or both built- in display panel and external monitor.

Four

53