Fujitsu C-4120 manual You can not access your hard drive continued

L i f e B o o k C S e r i e s f r o m F u j i t s u

T r o u b l e s h o o t i n g

Problem

You can not access your hard drive (continued).

Keyboard or Mouse Problems

The built-in keyboard does not seem to work.

Possible Cause

2.The wrong drive designator was used by an application when a bootable CD-ROM was used to start the notebook.

3.Security is set so operating system can not be started without a password.

1.The notebook has gone into Suspend mode.

2.Your application has locked out your keyboard.

Possible Solution

2.Verify drive designator used by application is in use by the operating system. When the operating system is booted from a CD-ROM, drive designations are automatically adjusted. (See Primary Master Submenu in the BIOS guide. See page 44 for more information.)

3.Verify your password and security settings. (See Security menu in the BIOS guide. See page 44 for more information.)

1.Push the Suspend/Resume button.

2.Try to use the ErgoTrac pointing device to access the Start menu and then the ShutDown menu and restart the System. If this fails, then reset your notebook using the reset button located on the rear panel.

Five

You have installed an external keyboard. External keyboard is not functioning.

1.Your external device is not properly installed.

2.Your operating system software is not setup with the correct software driver for that device.

1.Re-install your device.

2.Check your device and operating system documentation and activate the proper driver.

65