Manuals / Fujitsu / Computer Equipment / Scanner

Fujitsu fi-5650C specifications Extended memory board, Hint, Contents

Models: fi-5650C

1 161

Download 161 pages 49.56 Kb

Page 151

9.1 Extended memory board

CONTENTS

Introduction

1 NAMES AND FUNCTIONS OF PARTS

2 BASIC SCANNER OPERATION

3 SCANNING VARIOUS TYPES OF DOCUMENTS

4 DAILY CARE

5 REPLACING CONSUMABLES

6 TROUBLESHOOTING

7 ONLINE SETUP

8 DOCUMENT SPECIFICATION OF ADF 9 OPTIONS

9.1 Extended memory board

10 SCANNER SPECIFICATIONS

Appendix

9.1 Extended memory board

The scanning performance is optimized at higher resolution settings by installing additional memory boards. Additionally, with added memory boards, scanning both sided color sheets at 401 dpi or at higher resolutions will not be suspended or interrupted.

1. Remove the screws on the rear side of the scanner, and remove the covers.

2. Insert the memory boards into the slots and push it down so that the boards are fixed in by the claws.

3. Secure the screws to fix the covers.

The following memory boards are recommendable for using with fi-5650C Color Image Scanner.

Manufacturer

Model

Memory Size

Micron Technology MT4LSDT1664HG-13E 128MB

Micron Technology MT8LSDT3264HG-13E 256MB

ATTENTION

Install 2 memory boards whose specifications must be equal, otherwise this option might not operate correctly.

HINT

To confirm the instalation of the extended memory board, check the scanner memory value of [standard information] on [Device information] panel in [Software operation panel].

All Rights Reserved, Copyright (C) PFU LIMITED 2004

Image 151

Fujitsu fi-5650C specifications Extended memory board, Hint, Contents

Contents

All Rights Reserved, Copyright C PFU LIMITED fi-5650C Image Scanner Operators GuideP3PC-E957-01EN CONTENTS→ Contents Map FeaturesIntroduction CONTENTSIntroduction CONTENTS MAP6 TROUBLESHOOTING 7 ONLINE SETUPFCC declaration Regulatory InformationCONTENTS CONTENTS Regulatory Information Continued from the previous pageCanadian DOC Regulations Bescheinigung des Herstellers / ImporteursCONTENTS International ENERGY STAR ProgramRegulatory Information Continued from the previous page Regulatory Information Continued from the previous page Use in High-safety ApplicationsAbout the use of mercury CONTENTSCONTENTS TrademarksHow Trademarks Are Indicated In This Manual Use in High-safety ApplicationsManufacturer Trademarks Continued from the previous pageCONTENTS CONTENTS Note, LiabilityCONTENTS Safety PrecautionsPreface Warning Indications Used In This ManualCONTENTS Symbols Used In This ManualPreface Continued from the previous page HINTCONTENTS About MaintenanceScreen Examples In This Manual Warning LabelWipe any dust from the power plug Safety PrecautionsCONTENTS Use only specified AC cables and connector cablesTurn the scanner OFF if it is damaged Safety Precautions Continued from the previous pageCONTENTS Do not use the scanner if you smell strange odorFirmly insert the power plug Safety Precautions Continued from the previous pageCONTENTS Do not install the scanner on unstable surfacesAvoid any contact when scanner is in use Safety Precautions Continued from the previous pageCONTENTS Do not use aerosol sprays to clean the scannerCONTENTS Safety Precautions Continued from the previous pageDo not try to move or lift the scanner alone CONTENTS Chapter 1 NAMES AND FUNCTIONS OF PARTSPlease refer to 2.2 Loading documents onto the ADF 1.1 Names and functions of parts Continued from the previous pageCONTENTS Refer to 1.2 Functions of the operator panel1.1 Names and functions of parts Continued from the previous page CONTENTS1.1 Names and functions of parts Continued from the previous page CONTENTSCONTENTS 1.2 Functions of the operator panelLaunches the linked application software CONTENTS Chapter 2 BASIC SCANNER OPERATIONCONTENTS 2.1 Turning the scanner ON/OFF2.1 Turning the scanner ON/OFF Continued from the previous page Power Save ModeCONTENTS Over A4-size paper 2.2 Loading documents onto the ADFCONTENTS A4-size paper or smallerCONTENTS 2.2 Loading documents onto the ADF Continued from the previous page2.2 Loading documents onto the ADF Continued from the previous page CONTENTS2.2 Loading documents onto the ADF Continued from the previous page CONTENTS2.2 Loading documents onto the ADF Continued from the previous page CONTENTSCONTENTS 1 2 3 4 52.2 Loading documents onto the ADF Continued from the previous page HINT 2.3 Scanning documents1 2 CONTENTSCONTENTS 2.3 Scanning documents Continued from the previous page1 2 2.3 Scanning documents Continued from the previous page CONTENTS1 2 2.4.1 FUJITSU TWAIN32 Scanner Driver 2.4 How to use the Scanner DriverCONTENTS CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageProcedure for Basic Scanning Operation CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageHINT CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageSetting Window for FUJITSU TWAIN32 Scanner Driver 2.4 How to use the Scanner Driver Continued from the previous page ResolutionScan Type Paper SizePreview button Image ModeReset button Scan button2.4 How to use the Scanner Driver Continued from the previous page Help buttonAbout... button Option... buttonStartup tab Rotation tabJob/Cache tab Generic tab2.4 How to use the Scanner Driver Continued from the previous page Config... buttonCompression tab Advance... buttonProcedure for Basic Scanning Operation 2.4.2 FUJITSU ISIS Scanner Driver2.4 How to use the Scanner Driver Continued from the previous page CONTENTSCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageHINT CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageHINT CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageHINT CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageConfiguration Window of FUJITSU ISIS Scanner Driver CONTENTS 2.4 How to use the Scanner Driver Continued from the previous pageImage Mode Resolution2.4 How to use the Scanner Driver Continued from the previous page Half toneBrightness ContrastADF Front Side 2.4 How to use the Scanner Driver Continued from the previous pageCONTENTS Scan Type2.4 How to use the Scanner Driver Continued from the previous page Paper LayoutAutomatic Size and Skew Detection More... button2.4 How to use the Scanner Driver Continued from the previous page Area... buttonCONTENTS CONTENTS Imprinter... buttonJEPG... button 2.4 How to use the Scanner Driver Continued from the previous page2.4 How to use the Scanner Driver Continued from the previous page Setup IPC... buttonCONTENTS DTC Variance End of Page DetectionOverscan GammaBackground Power savingDropout Color ReverseCONTENTS Chapter 3 SCANNING VARIOUS TYPES OF DOCUMENTSCONTENTS 3.1 Scanning double sided documentsCONTENTS 3.1 Scanning double sided documents Continued from the previous page3.1 Scanning double sided documents Continued from the previous page CONTENTSHINT CONTENTS 3.2 Scanning documents with different widthsCONTENTS 3.3 Scanning document longer than A3 size2. Using Adobe Acrobat 3.4 Saving scanned images in PDF formatCONTENTS 1. Using ScandAllCONTENTS 3.4.1 Using ScandAllCONTENTS CONTENTS CONTENTS 3.4.2 Using Adobe AcrobatCONTENTS CONTENTS CONTENTS HINT CONTENTSCONTENTS CONTENTS CONTENTS 3.5 Selecting a color to drop outCONTENTS 3.5 Selecting a color to drop out Continued from the previous pageCONTENTS 3.6 Skipping blank pagesCONTENTS 3.6 Skipping blank pages Continued from the previous page3.6 Skipping blank pages Continued from the previous page CONTENTSCONTENTS 3.7 Detecting double-feedsCONTENTS 3.7 Detecting double-feeds Continued from the previous page3.7 Detecting double-feeds Continued from the previous page CONTENTSCONTENTS 3.8 Correcting skewed documentsCONTENTS 3.8 Correcting skewed documents Continued from the previous pageHINT CONTENTS Chapter 4 DAILY CARE1. Cleaning material 4.1 Cleaning material and locations requiring cleaningCONTENTS CONTENTS 2. Locations requiring cleaningCleaning the Brake roller, Glasses, Sheet guides, Plastic rollers 4.2 Cleaning the ADF4.2.1 Cleaning the ADF using with a cloth moisten with Cleaner F1 CONTENTSCleaning the Feed rollers 4.2 Cleaning the ADF Continued from the previous pageCONTENTS Cleaning the Pick roller setCleaning the Pick arm 4.2 Cleaning the ADF Continued from the previous pageCONTENTS Cleaning the Chute roller4.2 Cleaning the ADF Continued from the previous page 4.2.2 Cleaning the ADF using Cleaning paperCONTENTS CONTENTS Chapter 5 REPLACING CONSUMABLESCONTENTS 5.1 Consumable and Replacement CycleCONTENTS 5.1 Consumable and Replacement Cycle Continued from the previous pageGuidelines for Consumable Replacement Cycle CONTENTS 5.1 Consumable and Replacement Cycle Continued from the previous pageCONTENTS 5.1 Consumable and Replacement Cycle Continued from the previous pagePick Roller see 5.3 Replacing the pick roller set 5.1 Consumable and Replacement Cycle Continued from the previous pageCONTENTS Brake Roller see 5.2 Replacing the brake rollerCONTENTS 5.2 Replacing the brake rollerCONTENTS 5.3 Replacing the pick roller setCONTENTS Chapter 6 TROUBLESHOOTINGCONTENTS 6.1 Removing jammed documentsHINT 6.2 Indications of operator panel for errorsTemporary Errors CONTENTSCONTENTS Device alarmCONTENTS Trouble Shooting CONTENTSThe check list CONTENTSCONTENTS Trouble ShootingPush the power button Symptom The scanner cannot be turned ONCONTENTS Back to the trouble shooting indexCONTENTS CONTENTS Symptom Indication on the Function No. display goes outCONTENTS Symptom The scanning does not startCONTENTS Symptom Quality of scanned pictures or photos is not satisfactoryCONTENTS Symptom Quality of scanned text or lines is not satisfactoryCONTENTS Symptom Images are distorted or blurredCONTENTS Symptom Vertical lines appear in the scanned imagesCONTENTS Symptom Double-feed errors occur frequentlyCONTENTS Symptom Pickup errors occur frequentlyCONTENTS Symptom Paper jams occur frequentlyCONTENTS Symptom The scanned images are elongatedCONTENTS Symptom There is a shadow on the leading edge of the scanned imagesOthers Trouble of connection to your PCFeed system trouble Imaging system troubleCONTENTS 6.4 Checking labels on the scannerCONTENTS Chapter 7 ONLINE SETUPCONTENTS 7.1 Online setup1 Double feed 2 Page Edge Filler Power saving 7.1 Online setup Continued from the previous pageCONTENTS Offset adjustmentCONTENTS 7.2 Double-feed detectionCONTENTS 7.3 Setting of Page Edge FillerCONTENTS 7.4 Setting dropout colorCONTENTS 7.5 Setting of pre-pick modeCONTENTS 7.6 Resetting the consumables countersCONTENTS 7.7 Adjusting The OffsetCONTENTS 7.8 Adjust the magnificationCONTENTS 7.9 Power savingCONTENTS Chapter 8 DOCUMENT SPECIFICATION OF ADFCONTENTS 8.1 Document sizeCONTENTS 8.2 Document qualityReplacing parts 8.2 Document quality ContinuedCONTENTS CleaningLarge Size 8.3 Maximum ADF capacityCONTENTS Small SizeCONTENTS 8.4 Area not to be perforatedCheck overlapping and length 8.5 Double feed detection conditionsCheck overlapping Check lengthCONTENTS 8.6 Background Color Areas1. Shape 8.7 Job Separation SheetCONTENTS 2. Document SpecificationsCONTENTS Chapter 9 OPTIONSCONTENTS 9.1 Extended memory boardHINT CONTENTS Chapter 10 SCANNER SPECIFICATIONSCONTENTS 10.1 Basic SpecificationsCONTENTS 10.1 Basic Specifications Continued from the previous pageCONTENTS 10.2 Installation specificationsCONTENTS 10.3 External dimensionsCONTENTS 10.3 Physical dimensions Continued from the previous pageCONTENTS AppendixCONTENTS Appendix 1 Before using Scan button and Send to buttonFor Windows 98, Windows Me, Windows 2000 and Windows XP HINT CONTENTSFor Windows 95 and Windows NT CONTENTS