Fujitsu FMW4503TS128A01 manual 25ter AT Commands, Command Specification Description

V.25ter AT Commands

Command			Specification	Description
+GMI		Return ‘Lucent Data/Fax’		Manufacturer Identification
+GMR		Return Lucent driver version number (e.g., 5.54)		Version/Revision Information
+GMM		Return ‘H.324 video-ready rev. 1.0’		Modem Identification
AT+A8E=<v80>	v8o	1:	The default value disables the CI origination	Defined for two conditions: as a
			option while in V.8 negotiation. However, the	parameter to configure V.8
			modem, when initiating the call as a data call,	originating and answering
			detects ANSam and is capable of starting in	operation while the DCE is
			V.34 mode.	on-hook.It initiates an action if
		6:	Enables DCE control of V.8 and CI option.	the DCE is off-hook. If enabled,
				V.8 negotiation does not
				preclude simultaneous
				implementation of other
				negotiation means like V.8bis,
				V.18, or V.32bis.
	v8a	1:	The default value disables the CI option while
			in V.8 negotiation. However, the modem,
			when answering a call, sends the ANSam
			and is capable of starting in V.34 mode.
		5:	Enables DCE control of V.8 and CI option.
	v8cf	21h:	Call function for H.324 calls.
		c1h:	Call function for DSVD calls.
AT+A8E?				Report current values of
				subparameter.
AT+A8E=?				Report supported ranges of
				values <v8o>, <v8a>, <v8cf>
+A8I:<v8cf><CR>				This indication is used by an
				answering DCE if +A8E,
				<v8a>!=0, to indicate detection of
				a V.8 CI signal, and report the
				recovered Call Function octet(s).
				Value <v8cf> is a hexadecimal
				code octet that can take values
				as shown above in +A8E
				command.
+A8M=<hexadecimal		Refer to V.8 document for coding.		Directs the DCE to send a V.8
coded CM or JM octet				CM or JM signal using the
string>				specified hexadecimal coded
				string.
+A8A:<type><CR>		1:	Indicates V.8 ANSam signal flags.
		0:	Indicates no ANSam signal detected.

AT Commands Table 86