5.1 Operating Optical Disk Drive
5.1.2 Note
To maintain the performance and reliability of the drive, keep the following point in mind:
!
!
When the drive is in the busy state, do not eject the optical disk cartridge.
Particularly, do not manually eject the cartridge by force.
Be careful sufficiently not to insert the different drive (etc. floppy disk) or substance, so it is cause of the accident.
5.1.3 Inserting cartridge
Insert the cartridge as explained below. (See figure 5.2)
(1)When the drive power is on:
1)Make sure that no disk cartridge is in the drive.
2)Keep the cartridge shutter surface upward.
3)Insert the cartridge, shutter first, into the disk insertion slot.
4)Push the cartridge into the slot until it completes moving below (a little further in than the operator panel).
Loading is started when the cartridge is inserted. After several seconds, the BUSY LED indicator lamp is turned on and immediately turned off to complete loading.
Notes
1)The cartridge must be completely inserted until the BUSY LED indicator lamp is lit.
2)If the cartridge is inserted by pushing either left or right side of the cartridge rear, it may not be inserted completely. Be sure to push the central part straight into the drive until it is completely inserted.
3)If the BUSY LED indicator lamp does not light when the cartridge is inserted, once eject the cartridge by pressing the eject/BUSY LED button and insert it again.
4)If you attempt to insert the cartridge by force, trouble may result in the drive. In such a case, be sure to once remove the cartridge and check the insertion direction and the face and back of the cartridge before inserting it again.
(2)When the drive power is off:
1)Make sure that no optical disk cartridge is in the disk drive.
2)Keep the cartridge shutter surface upward.
3)Insert the cartridge, shutter first, into the disk insertion slot.
