3.8 Cable Connections

3.7 Mounting

3.7.1 Checks before mounting the drive

Before mounting the optical disk drive in the system cabinet, check whether the jumper settings are set correctly.

3.7.2 Mounting procedure

How the drive is mounted depends on the system cabinet structure. Determine the mounting procedure in consideration of the requirements of each system. This section contains the general mounting procedure and check items.

See Section 3.2 for details on mounting drive.

1)Tighten four mounting screws to secure the drive in the system cabinet.

!The drive has ten mounting holes (both sides: 3 2, bottom: 4). Secure the drive using the four mounting holes on both sides or the bottom.

!Use mounting screws whose lengths are 3 mm or less from the external wall of the mounting frame of the drive when they are tightened. (See Figure 3.6)

!When mounting with screws, the screw tightening torque should be 0.4 to 0.45Nm (4 to 4.6kgfcm).

!Be careful not to damage the parts on the PCA when mounting the drive.

2)After securing the drive, make sure that the drive does not touch the chassis of the system cabinet. There must be at least 1.5 mm clearance between the drive and chassis. (See Figure 3.6)

3.8Cable Connections

Use the following cables to connect the drive to the system. See Subsection 3.4 for details on the connector positions and cable requirements.

Power supply cable

AT interface cable

DC ground cable (if required)

The general procedure for cable connection and notes on connecting cables are given below. Pay attention to the insertion direction of each cable connector.

C156-E205-01EN

3-21

Page 69
Image 69
Fujitsu MCJ3230AP manual Checks before mounting the drive, Mounting procedure