Fujitsu MPG3XXXAH-E manual Information to be read by Identify Device command 6

Table 5.5 Information to be read by IDENTIFY DEVICE command (6 of 6)

*20 Word 89: Time required for SECURITY ERASE UNIT command to complete. MPG3204AH-E = 0004H: 8 minutes

MPG3307AH-E = 0006H: 12minutes

MPG3409AH-E = 0008H: 16 minutes

*21 Word 93: Hardware reset result. The contents of bits 12-0 of this word shall change only during the execution of a hardware reset.

Bit 15:	0
Bit 14:	1
Bit 13:	1 = device detected CBLID- above VIH (80-conductor cable)
	0 = device detected CBLID- below VIL (40-conductor cable)
Bit 12-8:	Device 1 hardware reset result. Device 0 shall clear these bits to zero.
	Device 1 shall set these bits as follows:
	Bit 12:	0	= Reserved
	Bit 11:	0	= Device 1 did not assert PDIAG-
		1	= Device 1 asserted PDIAG-
	Bit 10-9: These bits indicate how Device 1 determined the device number.
		00		= Reserved
		01		= a jumper was used
		10		= the CSEL signal was used
		11		= some other method was used or the method is unknown
	Bit 8:	1
Bit 7-0:	Device 0 hardware reset result. Device 1 shall clear these bits to zero.
	Device 0 shall set these bits as follows:
	Bit 7:	0
	Bit 6:	0	= Device 0 does not respond when Device 1 is selected
		1	= Device 0 responds when Device 1 is selected
	Bit 5:	0	= Device 0 did not detect the assertion of DASP-
		1	= Device 0 detected the assertion of DASP-
	Bit 4:	0	= Device 0 did not detect the assertion of PDIAG-
		1	= Device 0 detected the assertion of PDIAG-
	Bit 3:	0	= Device 0 failed diagnostics
		1	= Device 0 passed diagnostics
	Bit 2-1:	These bits indicate how Device 0 determined the device number.
		00		= Reserved
		01		= a jumper was used
		10		= the CSEL signal was used
		11		= some other method was used or the method is unknown
	Bit 0:	1
*22 Word 94: Automatic Acoustic Management
Bit 15-8:	0
Bit 7-0:	Current automatic acoustic management value

5 - 34 C141-E116-01EN