Fujitsu MPG3XXXAH-E manual Operations

5.6.3	Ultra DMA data transfer		5	- 97
5.6.3.1	Initiating an Ultra DMA data in burst		5	- 97
5.6.3.2	Ultra DMA data burst timing requirements		5	- 98
5.6.3.3	Sustained Ultra DMA data in burst		5	- 101
5.6.3.4	Host pausing an Ultra DMA data in burst		5	- 102
5.6.3.5	Device terminating an Ultra DMA data in burst		5 - 103
5.6.3.6	Host terminating an Ultra DMA data in burst		5	- 104
5.6.3.7	Initiating an Ultra DMA data out burst		5	- 105
5.6.3.8	Sustained Ultra DMA data out burst		5	- 106
5.6.3.9	Device pausing an Ultra DMA data out burst		5	- 107
5.6.3.10	Host terminating an Ultra DMA data out burst		5 - 108
5.6.3.11	Device terminating an Ultra DMA data in burst		5 - 109
5.6.4	Power-on and reset		5	- 110
CHAPTER 6		OPERATIONS	6	- 1
6.1	Device Response to the Reset		6	- 1
6.1.1	Response to power-on		6	- 2
6.1.2	Response to hardware reset		6	- 3
6.1.3	Response to software reset		6	- 4
6.1.4	Response to diagnostic command		6	- 5
6.2	Address Translation		6	- 6
6.2.1	Default parameters		6	- 6
6.2.2	Logical address		6	- 7
6.3	Power Save		6	- 8
6.3.1	Power save mode		6	- 8
6.3.2	Power commands		6	- 10
6.4	Defect Management		6	- 10
6.4.1	Spare area		6	- 11
6.4.2	Alternating defective sectors		6	- 11
6.5	Read-Ahead Cache		6	- 13
6.5.1	Data buffer configuration		6	- 13
6.5.2	Caching operation		6	- 14
6.5.3	Usage of read segment		6	- 15
6.6	Write Cache		6	- 20

xii C141-E116-01EN