3.5.2Factory default setting
Figure 3.15 shows the default setting position at the factory. (Master device setting)
DC Power Connector | Interface Connector |
Figure 3.15 Factory default setting
3.5.3Jumper configuration
(1)Device type
Master device (device #0) or slave device (device #1) is selected.
2 | 4 | 6 | 8 |
| 2 | 4 | 6 | 8 |
|
|
|
|
|
|
|
|
|
| = shorted |
1 | 3 | 5 | 7 | 9 | 1 | 3 | 5 | 7 | 9 |
(a) | Master device | (b) | Slave device | ||||||
Figure 3.16 Jumper setting of master or slave device
Note:
When the device type is set by the jumper on the device, the device should not be configured for cable selection.
(2)Cable Select (CSEL)
In Cable Select mode, the device can be configured either master device or slave device. For use of Cable Select function, Unique interface cable is needed.
3 - 14 |
|
