4.2Operating the F4 Key
The F4 key is a
Registering a program to the F4 key
1.Press the F4 key twice to show the F4 REGIS- TER menu. (Each press of the key displays the
2.Select the number to register then push the left button. For example, select "1" and the
[F4 REGISTER]
1[ ]
2[ ]
3[ ]
4[ ]
5[ ]
6[ ]
7[ ]
8[ ]
9[ ]
0[ ]
3.Select 2 TITLE then push the left button. A keyboard appears.
4.Use the keyboard to enter program title, using up to 15 alphanumeric characters.
1)Place the cursor on a desired character.
2)Push the left button. Chosen char- acter appears below TITLE in the menu. Numeric and alphabet may be directly entered from keyboard- equipped control unit.
3) Repeat steps 1 and 2 to complete Keyboard the title.
4)Finally, place the cursor on END then push the left button.
1BACK
2TITLE
3OPERATION
4SAVE NO/YES
1
2 
3 
4 
5 
6 
7 
8 
9 
0 
BS Q
W
E
R
T
Y
U
I 
O
P
- A
S
D
F
G
H
J 
K
L 
+
Z X C V B N M , | . ? | ||||
" # / |
|
|
| END |
|
5.Select 3 OPERATION then push the left button. The message "MACRO RECORDING" PRESS F4 KEY TO END RECORDING." appears at the lower
6.Operate the equipment to select setting content (max. 20 steps). For example, set the range for 16 nm, interference rejector for 3 and echo averaging for 2. The method for counting steps depends on the content of the step as follows:
Main menu, box menu: Each setting counts as one step. For example, if you set 20 items, that counts as 20 steps.
Note: When you reach 20 steps the message disappears and the macro recording mode ends. If you could not record all the steps you require, do step 5 again, staying within 20 steps.
7.After setting the equipment as desired, press the F4 key.
8.Select 4 SAVE then push the left button.
9.Select YES then push the left button.
10.Push the right button four times to close the menu.
27
