Genicom microLaser 210 - page 112

Publication No. GEG-99054 Genicom Mar 00
5-28 microLaser 210 User Guide
Warning Messages and Error Messages
Error Messages
The table below lists error messages, the possible causes of each error,and the act ions required to
recover from each er ror.
Error Message
Line 1
Error Message
Line 2
Possible Cause Action
E2 JAM MISFEED
E3 JAM FUSER
E4 EXIT JAM
E6 JAM OFF.TRAY
E7 JAM DUPLEX
Remove Paper There is a paper jam
inside the printer.
Remove the jammed paper from
the indicated location.
Seethe“PaperJams”onpage
5-4 for information about
removing paper jams.
E5 COVER OPEN Close TopCover The top cover is open. Closethe top or rear cover.
E5 COVER OPEN Close Rear
Cover
The rear cover is open. Close the of fset tray cover.
J3 TONER CART. Install/Reset The toner cartridge is
not installed, or an
incorrect cartridge is
installed.
Install the correct toner cartridge
according to the specifications.
See “Replacing the Toner
Cartridge” on page 4-3.
TRAY 1 MISSING In sert Tr ay Tr ay 1 is not i n the
printer.
Insert the tray.
TRAY 2 MISSING In sert Tr ay Tr ay 2 is not i n the
optional feeder.
Insert the tray.
TRAY 3 MISSING In sert Tr ay Tr ay 3 is not i n the
optional feeder.
Insert the tray.
LOAD PAPERTRAY1 Paper Size/
Paper Type
Tray1 is empty. Load paper into the tray.
LOAD PAPERTRAY2 Paper Size/
Paper Type
Tray2 is empty. Load paper into the tray.
LOAD PAPERTRAY3 Paper Size/
Paper Type
Tray3 is empty. Load paper into the tray.
LOAD PAPERFRONT Paper Size/
Paper Type
The front trayis empty. Loadpaper into the tray.
PAPER S IZE ERR OR Paper Size/
Press Start
The paper size is not
supported by the
printer.
Check paper size specifications
andloadpaperthatmeets
specifications.
OUTPUT TRAY FULL Remove Paper The output tray is full. Re move paperf romthe tray.
OFFSET TRAY FULL Remove Paper The offset output tray is
full.
Remove paper from the tray.
PAPER PATH ERR OR CloseFaceUp Thefaceuptrayis
open.
Close the face up tray.